The building was large, but not unusual, with an equally sizeable floor sheathed with OSB. What was unusual was the enormous amount of rain that unexpectedly doused the site during construction. Luckily, the designers had the foresight to include temporary expansion joints, and the project continued without a hitch after the deluge dried up.
While temporary expansion joints may seem like a minor detail, omitting them can have severe consequences where humidity or moisture come into play. When wood structural panels (plywood and OSB) are exposed to moisture during construction, the wood absorbs the moisture, and panel expansion may occur.
“I recall examples illustrating the importance of expansion joint detailing,” emphasized Robert Kuserk, P.E., Field Services Manager for APA. “APA has encountered several projects where floor panels expanded, causing the first and second-story walls to lean out of plumb by up to 1-1/2 inches, compelling the construction crew to realign the walls. This experience has served as a stark lesson for engineers who, regrettably, did not prioritize specifying this detail upfront, forcing them to grapple with the aftermath. Consequently, they now include these joints in their project specifications to avert similar challenges in future endeavors.”
For buildings less than 80 feet in length or width, the recommended 1/8-inch spacing of floor, wall or roof sheathing panels will usually allow panels to expand without affecting wall alignment, assuming no unusual moisture conditions or aggressive fastening schedules. The larger the building, the larger the potential for adverse effects to framing caused by expansion of moisture-laden panels, Kuserk explained. In large buildings with continuous floor or roof decks constructed of plywood or OSB, the effects can be more noticeable. Results of moisture-related expansion can include the displacement of framing at the building’s perimeter and out-of-square window and door openings.
Builders can eliminate displacement from the equation during construction by using temporary expansion joints for buildings that have a length or width exceeding 80 feet. This should be done in addition to providing 1/8-inch spacing at all panel ends and edges.
